Edelbrock Performer RPM Small Block Chevy Intake Manifold

Beschrijving

De Edelbrock  Performer RPM inlaatspruitstuk is ontworpen voor 1955-86 262-400 c.i.d. Chevy V8’s voor maximaal vermogen en een brede koppelcurve voor krachtige straat- / bootmotoren.

Biedt vermogen als een single-plane  en gasrespons als een dual-plane.

Heeft voorzieningen  om een olievulbuis in te frezen. Geen voorzieningen voor uitlaatverwarming of standaard choke.

Geschikt voor laat-model thermostaathuis, airconditioning, dynamo en H.E.I. verdeler Past op gietijzeren Chevrolet Bowtie koppen, maar past niet op gietijzeren koppen uit 1987 en later.

De Edelbrock Performer RPM Inlaatspruitstukken passen niet onder de standaard Corvette-motorkap.

DOCUMENTS & INSTALLATION NOTES

performer installation instructions

SPECS

Availability	Available
Application	Application Specific
UPC	00085347071012
Series	Performer RPM
Grade Type	Performance
Gasket Or Seal Included	No
Vehicle Model	Chevrolet
Availability Note	Available to Order
Warranty	12 Months
Ec Basic Operating Rpm Range	1500-6500 RPM
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Manifold ht: A-4.20″, B-5.25″ (.70″ taller than #2101); Carb pad height: 4.27″; Carb recommendations: Edelbrock AVS2 or Performer Series 650-800 cfm. Use bracket #8031 or #8036 for 1972-78. Port exit dimensions: 1.16″ x 1.92″; Recommended intake gasket: Edelbrock #7201. Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS. Use #8504 Edelbrock bolt kit. Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage. NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal. DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread. Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum. Will not fit under stock Corvette hood. Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Center Maximum Height	4.720 in
CNC Ported	No
Finish	Satin
Front Maximum Height	4.200 in
Material	Aluminum
Rear Maximum Height	5.250 in
Single Or Dual Plane Type	Dual